I'm trying to mount a clone to a leaf blower like someone did in this pic.
Trouble is, they had to smash the exhaust to get it to fit flush.
Any simple way to raise the exhaust straight up to clear the impeller housing?
I cant find these, so maybe some can help.
What is the bolting measurements for the Lifan 4 hp LF160? Also, what is the measurement from the engine bottom to the center of the shaft?
I was looking to use the Predator 212, but I need to mount the back almost flush, and the exhaust sticks out over the rear of the engine.
What is the easiest way to move the exhaust towards the front or straight out to the side?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.