Recent content by gasser

Took my kid to the Oregon Steam Up today. Found this old Mono Line chainsaw with an AH-47 in it at the swap meet. Turns over, has compression, and spark. Should be an easy one to get running. Now I need to figure out what to put it in.

Almost $60 through UPS, unless you know of a cheaper carrier. Shipping these little motors is becomeing cost prohibitive.

That guy is a hack, at best. In regards to the ez-turn wrench, I use a modified speed wrench. Works like a charm. Have probably done upwards of 1000 seats that way.

Bump

Old Kwik-Way valve grinder. Has been sitting a lot of years. Runs smooth. Only real damage I see is a missing knob on one of the levers. Dont use it, and it takes up space. $500. Located in Sandy OR.

Still have it.

Still have it.

I've been trying to locate some dimensions of the old Beam / Hiawatha / Western flyer Doodlebug. -Wheelbase -Tire diameter -Chassis height I'd like to build a doodlebug dragbike, but instead of cutting up a good old frame I'd rather just build one close as possible. With those dimensions, I...

Now on Ebay. http://rover.ebay.com/rover/1/711-53200-19255-0/1?icep_ff3=2&pub=5575378759&campid=5338273189&customid=&icep_item=113654638715&ipn=psmain&icep_vectorid=229466&kwid=902099&mtid=824&kw=lg&toolid=11111

$250 shipped.

Have a complete, good running GX390. Came off a commercial water pump that sucked a rock and blew up the impeller. $350 shipped. Can email or text pictures.

Bump. Still available.

Sent.

Hope posting this link works. Rad book I found about minibike racing. Published in 1972. https://www.instagram.com/p/Bpir-42hs8j/?utm_source=ig_share_sheet&igshid=142kfxoz4d965

Will also trade for 6x3.5 or 6x4 Azusa Tri-star wheels.