OK so i measured the dimensions of an old 5 hp. clinton.
width= 2 and 3/4 inch
height= 6 inches.
could this be right?
these are the holes i have drilled in my mounting plate
and i need a new engine
ok well i dont really care at all what the engine plate looks like, im just curious what engines will fit that pattern? a 6.5 clone? and help is appreciated
i have a manco thunderbird. it had a 5 hp Clinton engine on it. it ran like crap.
I took it off only to realize the guy who had it before really forced it into that frame. im talking bent mounting bolts and it appears he drilled right through the side of part of the frame. Take a look at the...
i bought it for 175 cash... the guy said it was a manco thunderbird or something? mid eighties or so. It screams, around 35 or so. 5 hp briggs. rides pretty rough. backfires a bit. no exhaust pipe. fire comes our of where it should be. I think he custom built part of the carb, like the choke...
hey dude any idea what size screw i need for my drive shaft. its a 3.5 briggs from like the 70s. its 5/8 diameter if that helps. The screw fell off and disappeared
my output shaft screw came off and my torque converter fell apart haha. But i dont know what size screw im lookin at? its a briggs 3.5 hp probably from the seventies? and the shaft size is 5/8
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.