pknopp's latest activity
-
PHi everyone, new to the forum. I bought his 1970 Speedway Shark last fall. I didn't know much about it when I bought at it other than I...
-
Ppknopp replied to the thread 1960 Percival Hellcat.Not perfect but I think it works for leaving it original.
-
-
Ppknopp replied to the thread 1960 Percival Hellcat.Working on the seat. I want to save as much of the original as possible. The back cleaned up amazing for 64 years old. I'm not a...
-
-
Ppknopp replied to the thread Can anyone help me find a belt for this mini bike.Not to suggest the obvious or what you have already done, but have to searched simply for the size as opposed to a specific application?
-
Ppknopp replied to the thread 1960 Percival Hellcat.I bought a kit. The needle and seat were a bit different so I used the old ones which were OK. First time I've fooled with these...
-
Ppknopp replied to the thread 1960 Percival Hellcat.We got the one West Bend running. https://youtube.com/shorts/IU1UVnazRgs?si=CgFmg3xkucEhoYaK
-
PWest Bend 580 (CW) completely restored.
-
PMiniGene has not been seen here since September, 2012.
-
Ppknopp replied to the thread 1960 Percival Hellcat.How about what was originally there? Not something one can find today? I see where a set screw was once used. I had the Kart outside...
-
Ppknopp replied to the thread 1960 Percival Hellcat.Thanks a lot Jim. I will get you the info but I couldn't see how it would work without a bolt in end. I can drill and tap but tell me...
-
PAlexander Reynolds EZ Rider 1 in great condition. Engine, brakes, foot pegs, and hand grips are not original. Engine is a 1968 Tecumseh...
-
Ppknopp replied to the thread 1960 Percival Hellcat.So what am I missing? No set screws or anything and doesn't align right.
-
-
Pdecided to use the little trailer and quester to bring some wood to the barn/shop yesterday, fired right up and never missed a lick.
-
Ppknopp replied to the thread 1960 Percival Hellcat.If I get time to work on it I can call. Otherwise on the Clinton. I have the clutch you see in the box. Not sure how it's supposed to...
-
PWhich shaft? The 580 West Bend will be 9/16, most likely with a 1/8" woodruff key (half moon). Some of them do have a full length 1/8...
