Recent content by spudkilla224

Hello everyone, I have a Comet centrifugal clutch that i filed out the keyway to work on my smooth shafted honda GX-160 clone, and filed out the keyway 2 make the clutch fit, it's a 3/4" bore clutch and my shaft is a 3/4" shaft clutch. So how do i make a 3/4" clutch slide on easily? Also how...

Were could I get steering dapeners at? Or could I make a bracket with extension doings that pull the handle bars to the true dead center?

Hello everyone I have an Azusa minibike and I'm putting a 2 stroke Tecumseh hsk845 in it and I was wondering what can I do to beef up and take the slop and make it so the steering has a little tension in it because I'll be doing 50mph.

Hello everyone I hav an 5 hp b&s flathead and I'm in the process of taking it apart and I ran into a problem which I think that the crank case side cover bearing bit onto the crank shaft. So basically I've done all the steps necessary to take the side cover off of the block, so how should I free...

Hello everyone, I have a B&S 5hp flathead, that seized up do to lack of oil. if i put a pipe wrench on the keyed part of the output shaft the piston spin but not easily. I think I threw the bearings, since its a model tat uses bearings not bushings. But what is the possibility of the hardened...

Hello everyone I was wondering how do I go about compressing valve springs on a 5 hp Briggs without buying a spring compression tool?

Hello everyone, I was wondering if I put a 250cc dirtbike engine in an Azusa frame minibike if it would be a bad idea? LOL :thumbsup:

Ok, were would one get some rim spacers at?

Sorry about that I meant this rim: AZ1197 - 6" Aluminum Wheel, 3-1/2" wide, 5/8" ID Bearing Would this 6" rim work?

Hello everyone, I was wondering if theese rims: AZ1144-MB - 5" Aluminum Wheel, 3" wide, 5/8" ID Bearing (2 required for Mini-Bike) Would fit theese tires: 8-6594 - 145 X 70 X 6 2-Ply Tubeless Knobby Tire Any help would be appreciated! :grind:

Hello guys/gals, I have a Azusa minibike and I really want to get some springer forks like the LIL INDIAN minibikes have. Not the chopper style, your standard minibike springer forks. Were could I buy a springer fork for an Azusa frame? :thumbsup:

Hello everyone I was wondering if anyone one knows what the HP of a Wisconsin Robin WI-390 Engine is? And what were they used for? :smile:

Hello everyone, I was wondering how many feet of pipe/tubing that you used for your minibike if you built one so i'd have sort of an estimate on how much i'd need 2 build one. :thumbsup:

Because my engine is on my minibike and my minibike is at a friends house, and i want an exact replica of the briggs flywheel puller.

This is the kind of tool i'm planning on building