Search results

First - My parts kit is complete. I'm going to be doing some cleaning and painting and then I'll be ready to put it all together. I just wanted some opinions/ideas from some guys with more experence than me on the setup before I assemble it all. It's a GX200 I got off eBay. I honed the cylinder...

How do I change the oil seal on the side of the block where the crank sticks through? the bearing is good so id rather not mess with it, but the seal is bad. got a new one ready to go. the block is all tore down.

I got a used GX200 from eBay a while ago. I'm planning on building a mud motor for my john boat. I was looking into electric starter kits as well , and I saw they came with charging coils. When I tore the GX apart I saw it already had the charging coils and magnets on the fly wheel (no ring...

just got a used GX 200 with a 2-1 reduction wet clutch. I haven't tried to take it apart yet. I was wondering how easy it is to get rid of the clutch? is it just bolted to the crank case cover? would I need to get a new crank case cover to run without it? any info like that. going to start into...