It's not so much that I'm looking for a solution, I'm just curious what step ups are typical with most of these standard horizontal shaft utility engines. I'm guessing that the distance between the end of this step up to the four bolt pattern must be controlled so that when someone wants to use...
Hi all,
I'm retrofitting a piece of equipment to my utility engine for my mini bike and I've noticed that I have three different types of crankshafts on my three engines. The part I'm concerned with is the increased diameter step up that occurs on the crankshaft right before the 4 bolt mating...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.