I think I have a h40 with no markins on it anywhere 1969 with bolt on plate on bottom of engine with intake on right side...piston that came out was 2.602 and I had it bored .020 and now its 2.645 what seems to be going on here?What piston can I put in it?Can I keep the same stroke or do I go...
Sent from my SCH-I545 using Tapatalk 2
I have went and had my Tecumseh H-40 bored and caint find a .20 piston and rings...and help is thanked it is 2.645 in size and I have no numbers on this 1969 H-40 the tag is missing.thanks
I need to have my h40 bored .20 over and my crank needs work also can I find a rod that will work after my crank is fixed?If not I will just do the block .20 and leave crank alone.Any help will be great.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.