gx160/200

Honda GX160/200 Camshaft from NR Racing (fits Predator motor) Camshaft, 252-0207: SPECIAL HIGH TORQUE GRIND FOR SMALL TRACKS, 6000 rpm, 22 lb Springs Required, 26 recommended. 10 to 1 Compression or higher recommend, however it will work with lower compression ratios. This is one of the best...

Hello all. I am in need of the top plate and stock throttle linkage for a Honda GX160/200 motor. I need the plate, throttle arm, the washer, spring, rod, and nut. Dont need any of the governor linkage or arms. PM me what you have.

This exhaust pipe has a drilled out muffler and is smoothed on the inside of the bolt on end,its been bead blasted and painted with VHT high temperature paint.it is quieter than an open header but is still high flow. $25 plus shipping.

Hey guys. I was wondering if any of you have used the single lighting / charging coil on the small GX engines. My qustion is.. Does it produce enough to run a small headlight and tail light? There is an aftermarket unit on ebay with a single coil that is priced right. It advertises a...

Pipe has about two hours on it. I think an OldMiniBikes member made it. Final step is 1.5" od. Should accept the RLV clamp on. It exited under the seat of my Cheeftah and Trail Horse. Should work well on Bonanzas and?? May also fit Predator? $20 + $10.95 Priority Mail shipping.

The rear mount on one of my blue HF clones broke. I'm looking for a replacement tank. Will a Honda GX160/200 tank bolt on a blue clone without mods? BTW anyone have a spare tank they'd like to get rid of?

I have a gx160 that is stock but i want to get it modified at the same time i do not want 2 spend to much money.My sprocket size is a 30 the teeth on clutch are 12.I know that i can remove the governor but what should i do after that:shrug:....

Are the parts interchangeable? Like if I wanted to put a GX160 head on my clone, will it work? Or like all the aftermarket parts for the GX200, will they work on my Clone? Get the where I am going?

Im rebuilding my 200 with some bigger parts so these have to go: - Dyno Cam 260: 0.260 lift & 235 duration - $40 - 22mm Mikuni Carb: 5 main jets 95,125,130,135,& 140 and 2 pilot jets 12.5 & 15, AGK intake manifold - $75 - Genuine Honda 18cc head milled 0.040", 26mm intake valve with...