mufflers

These four for 30.00 shipped or trade for a 12" shock or two etc ? . New

I have 2. $15 shipped each

Hello All, these fine mufflers fit the Briggs engines with a 3/4 NPT exhaust port, typically the 5HP engines. These will not work with 3-3.5HP engines. Only 3 for sale, gotta keep one for me! $13.00 to your door, lower 48 only

I just posted a thread in the classified section about these mufflers that a friend of mine has made. He has lots of them and I thought I would try and sell a few for him. I have this one on a black Tecumseh 5hp engine which is going on a Ruttman Spyder frame. I believe these will work on the...

A friend of mine has produced these mufflers which are exact duplicates to the Ruttman mufflers.

I have two new 97/ 99 cc Predator mufflers for sale. one with the header pipe and one with the engine flange cut off. $20 shipped each

NOS white $35 Raw polished (used for about half hour then sat on display on a shelf engine) $30 NOS red angled $25 NOS chrome muff with chrome plated 45 degree fitting $60. Please note: the muff is NOS but does have some rust spots on one side from improper storage, can be turned to...

Seen these at a local flea market over the weekend and thought I would ask if anybody could use any of them. I think they were asking $5 apiece for them and they had a "Tiawan" sticker right on them. :doah: If there is any interest in them I will post them up in the classified section and...

Muffler in good (painted) condition $15 Small round Briggs muffler $2 Briggs gas tank very clean w/mount $20 Briggs 6 hp vert. shaft muffler w/ bolts $5 2 Briggs air filter units. The one on the left has a brand new filter. 8 hp $20 The one on the right is a 12 hp with...

Tecumseh Go Kart Mini Bike Muffler - eBay (item 160550797778 end time Mar-02-11 17:30:31 PST) it looks like the guy has three of them listed that look brand new,I know that a few of you guys are looking for them, good luck

4 of them! Fresh and ready to bolt on. Clamps included. These are not new, just look like it due to my superior mad magic skilz :scared: Fits 1 1/4 pipe or header... Pay pal accepted. 25.00 ea shipped JJ

I have four vintage Tec mufflers for sale. The longest one (9 inches, part# 33224) was put on an engine for about 5 minutes and then removed and is in like new condition. Steps down and out. Includes original box and gasket, $45 shipped. The 2nd longest (8 inches) has been painted, but is...

for sale 13 brand new mufflers and 10 brand new briggs head gaskets 40.00 plus 20.00 shipped lower 48 . the parts are located in washington state . looking for the correct wheels for a 1961 caper cycle

Like to get a couple for our karts... PM me with what you have...

I have a couple DB-30's with the HF 6.5 motors. I had these headers on them. One with the small muffler and one with the larger one. I needed my motors quite so I modified some other. I will sell all of these pictured for? They have about 5 min running time. Serious. Once I bolted them on, I had...

tell me about the dual hotdog mufflers do they help keep the noise down while reducing back pressure? I would like to have some for my ride if they work:confused:

OK, I just read a thread on exhaust pipes and their effect on engine performance, but I'm wondering how the experts feel about using a muffler or multiple mufflers on a modified engine. I'm not after peak power, I'm more interested in increasing the engine performance while keeping the noise...

I have two Briggs engines, one is 8 cubic inches and the other is 9. i was wondering how much power each is putting out. I am also doing slight rebuilds on both of them but i cannot get the mufflers out. They both have a screw in type mufflers which over the years have become rusted to the...