stalls

Hello all, I am having trouble recently with my Coleman BT200x. It stalls as soon as i let go of the throttle, especially riding down a hill. Seems less powerful than before. I thought it was a clutch issue, and cleaned and oil the clutch. (the right way) No luck... Any suggestions? Thanks in...

Hi all, Purchased a Motovox MBX10 for my son for Christmas and have a stalling issue. It's a bit difficult to start cold but even after it warms up it stalls easily. Letting off the throttle and quickly reengaging it usually stalls it every time. Placing the choke lever at the halfway point...

Ok bought another complete db30 ( 50 ) decided to try and get it running before it becomes a parts bike , fresh gas , a shot of quick start and it idles fine ,,, however try to rev it or any load it stalls right out ,, any help would be great , thanx Shaky

I bought a baja minibike with a new predator 212cc engine. It was running fine and my grandson left the gas shut off on. I drained the oil, pulled the card off, checked the seat, cleaned it out, pulled the plug dried it out, put it all back together and it started right up. My grandson rode it...

Hey guys I know this is a rookie question but when I press the gas pedal on my kart all the way to full throttle it dies, when I let off it comes back again. Is this due to a lean or rich condition?

Hey Guys I need some help/advice/suggestions. I have a 2 HP BS I'm going to use on my Drover build but I have been fighting this thing for a while now. first issue I think some one drilled out the needle valve and re-tapped it to take a bigger needle valve (3/8 nut). When I pull the carb off...

My fairly new engine stalls only starts with choke, u can kind of ride it with half choke... It used to start right up with choke then put it forward and would stay started all day, i have stock everything on manco

first the tecumseh h35 is all stock exept for it has a diaphragm carb out of a tecumseh 85cc 2stroke snothrower. the carb has new diaphragm and gasket. and it also has the external primer bulb (hose leading from barb on base of carb to primer bulb). The problem is that when i sit on it and try...

I have an old 3.5 briggs that i can get to idle for a period of time but once I turn the thottle it stalls. It ran on the edger it was on with no problem. The govenor is the one that is over the flywheel. Could it be the plug? I checked the fuel pick up tube and it looked ok and clean...

In a recent post, I mentioned my son and I have been fiddling with a bike we put together from vintage parts and a 2-hp B & S motor out of an old but little used edger we had sitting around. The edger was set up to engage the choke when the trottle was in (or just past) the full open position...

I just put a 24mm Mikuni knock off on my flathead briggs, and it runs and idles great, but when I rapidly or aggressively pull the throttle it stalls. I can slowly open the throttle and it'll rev, but not if i pull it fast. Does the carb need adjusting, or different jets or what?

Hello all, just bought a new DB30 and it seems to start ok but it stalls as soon as you give it gas. You have do breath on the throttle ever so gentle to get it to accelerate. Gets a bit better once it warms up but still dies if you blurp it open from idle. I then decided to adjust the gov...