I've adjusted the idle screw and it helps a little but not enough. When I switch from start to run the back tire starts spinning fast and engine powers up without even twisting the throttle. What's up???
My clone takes off at full throttle as soon as I fire er up. I have the pilot jet drilled out with a #77 bit and the main drilled out with a #65. I am running a K&N air intake and a straight pipe. What do you think could be causing this? I ahve already ruled out the throttle or throttle...
I was crusin a pawn shop the other day for nuthin special and spied a lawn edger with a 3.5 IC Briggs. Most of the paint was still on the muffler and the whole rig was clean. I plunked down my $49 and loaded it up. I cleaned the swill that was in the fuel tank, changed the oil and yanked on the...
Mechanically complete bikes, collectable, and parts/acc still available. I've had 2 engines running {bench} but will need tuning. Third engine not tested but is in same condition as others. I do not sell junk-check my Ebay feedback under escootz. These are definately worth the effort for anyone...
Mechanically complete bikes, collectable, and parts/acc still available. I've had 2 engines running {bench} but will need tuning. Third engine not tested but is in same condition as others. I do not sell junk-check my Ebay feedback under escootz. These are definately worth the effort for anyone...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.