Made a raised engine plate for the coleman

[Bananas for Bonanzas]

i needed to make a raised plate for the coleman because i wanted to use a clone instead of the flattie. its not perfect, but thats ok because this bike is just a trail beater. i cut out the old mount, but it was pretty hacked up anyhow. once this bike is complete, im gonna strip it down, bead blast, and paint it.

[smallbikes88]

are you gonna use the jackshaft? It looks like the plate is in the way.

[Bananas for Bonanzas]

the chain sits beside the corner of the plate. theres about 1/4 inch clearance on each side of the chain. one i run it, if it happens to hit at all, i'll hack the corner off.