1inch

  1. minibikin'

    I need a 1inch throttle with this grip stat!

    Anyone have abused one they could part with? I really only need the grip bit I will take the whole assembly if need be. My Windber ride is about to come to life... Thanks in advance!
  2. S

    1inch clutch for 40/41 chain...never used

    Can't find a name on it. Has needle bearing instead of bushing. Located in Oregon. $70 shipped.
  3. jeep4me

    1" Bore Clutch, #35 Chain

    I have a like new 1" bore clutch, #35 chain, used very little. This clutch mounts on the end of the engine shaft, the shaft DOES NOT pass completely thru the clutch. I was going to use this on a project but I have since changed directions on that. Asking $60 shipped.
  4. COWBOY

    clutch for 1" shaft

    need a useable and afordable clutch for a 1" shaft have tons of stuff to trade also. i got lots of everything except cash.
  5. 125ccCrazy

    Noram 1inch clutch / 390 clone engine

    I have a Norm clutch, 12 tooth #35 chain with a 1" bore... This was on a 390 clone I got, everything is in good shape...... The drum has discoloration marks on the outside of the drum, the inside of the drum is clean, smooth and not discolored..not sure how that came about unless the previous...
  6. tomsprops

    1inch Tav2 Wanted

    Hello ,I'm starting a new project and need a Tav2 1"bore # 41 chain .I might be able to use a steel Tav/comet TQ unit as well ?
  7. machinebike

    Cut off 1inch crankshaft and modifying to a 3/4....

    I cut off the 1 inch shaft, left room to drill hole and tap with a 3/4 tap. I have a grade 8 3/4 bolt I mounted into it but when I turn the crankshaft, it is very, slightly crooked when i turn it. Any suggestions on how to get it straght after I already drilled and tapped? What about...
  8. M

    Wanted 1inch torque a verter

    Need 1" tav buy or trade let me know
  9. jeep2003

    1" torque converter

    im looking for a 1" shaft torque converter for my bronc i need the driver, driven, the belt, and preferably a steel backing plate. Im going to make the jackshaft go over to the right side of the bike. Also going to mount a band brake on that. Dont need a cover ill make my own. PM me or...
Top