98cc

  1. S

    Pre war 98cc villiers midget

    Got about 3 of these engines. They were built in wolvohampton England (20 mins from where i live). Only problem is the output shaft being tapered and threaded (roughly 17.5mm) finding a clutch can be a problem. This one has a modified pocket bike exhaust https://youtu.be/QjV3CQL8sy4
  2. hellsbells

    arctic cat ramrod restoration.

    Bike has been in family since new thanks to Bob fragoman I got a new top end! I just sent cylinder out for a fresh hone and now in process of putting back together the kawasaki 98cc engine and then ride a bit before I tear it down to restore. The bike was running before but decided after 34yrs...
  3. hellsbells

    arctic cat ramrod restoration.

    Thanks to Bob fragoman I got a new top end! I just sent cylinder out for a fresh hone and now in process of putting back together the stock kawasaki 98cc engine and then ride a bit before I tear it down. Bike was running before but decided after 34yrs It could use a little rebuild. :scooter: I...
  4. G

    98cc Lifan wont start

    Took carb apart, nothing there. Checked for spark, good. It's got gas in it and it's getting to the carb. I did run it in the rain a bit the other day, could I have clogged the valves doing that? I'm at a loss here. If the valves are clogged, can they be cleared easily? Need help, it's on a...
  5. adarter

    wanting carb for 98cc kawasaki.

    Im working on a ramrod motor and have the wrong carb. Help:scared:
  6. B

    Spare 98cc engine wanted

    I have a Lifan 98cc (97.7cc exactly, for technical purposes), side-valved (flathead) doodlebug engine that I would really like to have a spare handy for. It is a metric shaft, just a hair bigger than a 5/8 shaft, so I am looking for an exact replacement of this engine. If you have the stock carb...
  7. B

    Charging circuit for 98cc Lifan flathead?

    I acquired a used Lifan flathead (side valve) engine, which I have installed on a bicycle (I know, not a minibike, but not sure where else to ask, figured you guys would know). I downloaded a doodlebug manual so I would know what type of oil to use and a couple other things. The manual shows a...
  8. Wagdad

    Hensim 98cc pull start.

    Looking for a pull star for a 2008 hensim 98cc motor. I have no part number to go by. Any help would be greatly appreciated. I know nothing about these motors but need the starter for a mini bike project. Thanks # off of motor: HS152F 08L04612 Any info on motor helpful also.
  9. jeep4me

    98cc 2cycle Robin/Fuji/Jacobsen

    Here's a nice looking little motor. Wish I had some extra $$ for that one. minibike / gocart engine robin 98cc .
Top