Come to a little dead end not sure where to start I cut the stock muffler off the flange and what's left to the pipe on it. Cut up the hand truck I'm not sure my harbor freight hand truck has the same bends as yours. Was able to pick up a wire flux wire feed welder. Thanks for any guidance. :-)
Hi great job on the header just bought the hf hand truck. What kind of welder did you use for the header and intake? Thanks a lot for sharing your ideas.
Im having the same problem found this box stock header from ARC but dosent clear the seat. It's a 71 rupp enduro with the new style predator 212 with the cast valve cover I think it has the 196cc exhaust port because the pipe bolts right on with the engine off.
Any suggestions are much...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.