Hey guys I have a modded predator 212 hemi head that after I installed a dyno 310 cam (I’ve been running the motor with a cm265 cam with everything else’s the same, the only thing I changed was the cam and deepened the valve reliefs in the piston) has started making a tapping noise and will...
yes it’s on the stand as I mentioned, I didn’t clay or anything to get my measurements I just went by my piston deck height, head gasket thickness and went ahead and cut around .065 deep valve reliefs in piston, still had to cut a little deeper after taching it up to 8800 but have cut deep...
Hey guys this is my first post on here, I’d like to go ahead and thank you all for any and all replies and help, now, i have a modified hemi predator 212 that I run on kart dirt circle tracks of different sizes, my engine specs are stock bore/stroke, stock crank, arc billet flywheel 32 degrees...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.