I think that the 22mikuni may have some circuitry issues. It may be a faulty carb. Is the tilly that I was talking about better than the mikuni and do I have to have a fuel pump to run the tilly if the gas tank is above the carb. Also if any of you know where I can get a gx 160 QX2 crank from...
Rn I'm waiting to order a new crank cause I broke the end of the shaft while taking off the flywheel. I'm also going to buy a tilly304wx gas:shrug: is it good and do I need a fuel pump to run it. I'm getting a new carb cause if you go read my other post the 22mikuni is what I think is the...
Ok I just snapped off the flywheel bolt on the 160 crank and could not find a cheap one that was a 160 stroke so I guess I'm going to have to spend 70 dollars on a new one.
My motor has the following parts on it and only revs to ~4000rpm
GX160
Arc rod +.020
Flattop piston stock bore
File fit rings
CM pushrods
1.3 billet rockers
26lb springs(have duals but can't find someone to cut down the seat)
307 lift cam from nrracing (307lift, ICL 08, LS 07)
.045...
I never saw it myself but what the guy said is that it would spray out gas of the carb. He did get it to blip to 7500 once but it always stopped at 4000
My plug is what appears to be rich. The tip is black and gunk on it. The valves should not be floating cause they are the 26lb springs. Needle is in center posesition.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.