What size bolt is used on a 5/8" PTO shaft to hold clutch on? I've had a machine shop drill & tap 3/4" PTO's a few times and was going to have them tap this 5/8. Thinking it would be a smaller size bolt since thinner shaft?
Thanks in advance
I cannot speak for Tecumseh engines, however the Briggs engines with a 5/8" crank end I have had that were drilled and tapped from the factory were for a 1/4-28 bolt.
Michael
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.