I have a HF clone NIB. Without pulling flywheel, can anyone tell me if the flywheel has the magnets installed so i just have to add charging coil. If not, where do I get the magnets or flywheel?
Minibiking in the Carolinas
Just took the head off of my GX200 clone. The valve seats look pretty good, but the valves themselves are black, top and bottom. It appears the motor was run with an extremely rich carb. This a refurbish project. Also, one valve comes out easily but the other valve is captured by the...
Just cracked the crankcase on my GX200 clone. The governor appears not to be working. I found a plastic part in bottom of crank case and the arm is attached to nothing. What is the best thread for repair? I searched but did not recieve what I was looking for. Thanks for your time and help.
Is there a timing chain in the clone gx200 on the Baja Mini?
I am trying to remove head. Head bolts appear to need impact wrench.
Is this the normal removal procedure, with an impact wrench?
Have a Mini Baja clone I am trying to refurbish. What is the easiest and best way to remove flywheel?
I think the right question to ask is how do I get the nut loosened off the shaft without hosing up adjacent parts. Thanks in advance for your help.
Just got my Mini Baja, 197 cc, yesterday. Would anyone know the make of engine used in these bikes. Also, I have been reading some threads. Is the motor a Honda clone and if so, does some Honda parts fit this motor. Thanks in advance for your help and info.
Mini Biking in the Carolinas
Just picked up a used 2008 Baja Mini Heat in Savannah, GA. Kind of bad condition, but price was right and I did want a restoration project. I will be asking a lot of questions in the future. Right now my first two questions are what type/brand of motor is used in the Baja...