my predator pullstart won't engadge until it is almost all the way out. i get a 6 inch pull and im afraid i will break the rope. will the old clone starters fit? and it stalls all the time at idle :doah: the rpm's are up to just before the clutch catches.
new pred on a doodle .it will be all stock i wont spend over $300.on parts. we worked all day on it setting it up is up just before clutch engadgement.it rides great for 30 min till me butt gets sore. when we stop it will just die,cranking the throtle dont help. :confused: jet it ?
m8 1.25 hex heads
m8 1.25 hex heads pulled out. i used red thread lock. :censure: after 30 min I lost one bolt ant the other was 40% out.
drilling ok how, where ,with what? i have harbor freight titanuim drill bits. do i use a drill press or drill on engine? wire size? copper...
hi my yellow clone exaust studs fell out! i was riding and then the exaust was gone. i tried to remove the studs fron a old parts motor, pb buster and vice grips stripped them. should i mail order new studs for $2.00 and $10.95 shipping or get metric 1" BOLTS at lowes?
are the honda 160 and 200 carberators same? looking on line. and this honda carb is $26.00and some 160 carbs are around for $16.00(prob booleg)
2009 GX200UT VSD9 ENGINE, THA, VIN# GCAHT-1000001 Honda Small Engine CARBURETOR (1) Diagram and Parts
spring is here and i am seeing dead powerwasherson craigslist . bad hoses and pumps. has anyone used a honda powerwasher engine on a mini? should i buy some? they are selling $50-$75 posting good engine but washer needs etc etc . any hints what to look out for? like a welded pully on the...
getting warmer it time to tinker and get ready for a early spring in the north East. i lost my chain tensioner wheel in the fall on a doodle. i might take out a link or two and run without. I drained my carb and cracked the body
re-asembling. . glad to be back.