Search results

Rash

Major

Tight

Pulsating

Hay

Moonraker

https://www.oldminibikes.com/forum/mini-bike-discussion/138633-home-super-bronc-muffler.html

long

I currently don't have a battery. Working on getting a starter, battery, battery box and cables down the road. The SB is currently wired to run off of the lighting coil. I realize the lights will be dimmer at idle and brighter with rpm but my main question is what wattage did the low/high...

I am having a hard time figuring out what headlamp to use on my Super Bronc VT8-12 Do you guys run a 12 volt or 6 volt headlamp? My Super bronc is currently running a 12 volt H5006 headlamp but it is a low beam only and 12 volt. My tail lamp is an 1157 bulb and works correctly. The lighting...

https://www.oldminibikes.com/forum/mini-bike-discussion/138633-home-super-bronc-muffler.html I am starting to make a few pm me if you are interested..

I have a QT-50 that I eliminated the oiler and mix the fuel 50 to 1 and use the oil tank as a fuel reserve with a shut off valve between the 2 tanks. I recommend you make sure the fuel tank is completely clean of rust and then clean the carburetor multiple times, Replace the fuel lines and...

I am having a hard time determining what Decade my Hm100 was built. Hm100 159182P 9186D Was it built in 1969-1979-1989 or1999 How do you tell when you have just the engine and nothing else. I know it was built on the 186th day shift D but can't figure out the decade.

This muffler is extremely quiet at idle, the engine is louder than the muffler. The more discs inserted into the muffler the quieter it is. I like mine to have a little rumble to it at wide open throttle so I only inserted 2 discs. You could easily install 6 plus discs and it would be whisper...

Here are a few pictures of my home made super bronc vt8-12 muffler. I made it out of 3 inch exhaust tubing and 3/4 inch tubing for the inlet and exit pipes. I cut out and welded 2 discs into the inside of the exhaust tubing with holes drilled randomly throughout to equal the volume of the 3/4...

Here are a few pictures of my home made super bronc vt8-12 muffler. I made it out of 3 inch exhaust tubing and 3/4 inch tubing for the inlet and exit pipes. I cut out and welded 2 discs into the inside of the exhaust tubing with holes drilled randomly throughout to equal the volume of the 3/4...

I posted that Carburetor # incorrectly. Its 631660A.