Search results

I have 2 running minibikes for trade or sale in Hbg Pa. I am looking for a Puch, Honda PA50ii or Tomas 50cc or below with title please. Feel free to drop me a line or message me.

Hey wayne PM me and let me know if you have any old mini bikes up for sale. I am looking for a wonter project. Thanks friend

Hey Chris check your mailbox, it's full.

Was looking for a universal engine mount bracket. Feel free to PM me. Thanks Jay

Hi all. I have a 7hp Tecumseh that just came off a craftsman snow thrower. The carb does need to be tuned up or rebuilt but does run. The motor does not smoke. It has a 3/4 shaft. I am selling this for $80 and local pick up only. Thanks. Jay

Hello all, I am looking for a good running Tecumseh Carburetor that also has the primer bulb tube as well. Please PM me. I love these carbs and they always work well on my minibike projects. So easy to get them started initially. Thanks all.

Hey I was wondering if you might have a 7hp Tecumseh carb with primer bulb for sale?

Hey I was wondering if you might have a 7hp Tecumseh carb with primer bulb for sale?

Hold up. I just reviewed where I put this post and it should be in the wanted forum.

oops sorry guys. I am usually good about that. Please ignore this thread. Thanks again Aplyedmind

Hi guys. I was wondering if anyone had a good running Tecumseh snow carb which has the primer bulb for a 7 hp Tecumseh motor? These were mainly used on the Tecumseh Snow King snow throwers. Please pm me. Thanks Jay

Hey Wayne I hadn't heard from you in a while. I hope you and your family are doing well.

That has been my problem. There are times you want the circuit opened or closed which can pose a problem of trying to figure which switch to buy. I did bid a go kart kill switch which should work but I will keep you guys informed.

So if I got an open circuit tether and ran one wire to the coil and the other to a ground it should run until the tether is pulled or the rider falls off? Correct? I have installed kill switches before on my minis l without any issues. I guess when it came to the tethered switch it through me a...

I have been looking into a tethered type kill switch to install on my nephews soon to be mini bike. However on a few sites I have visited I have noticed that they often say the switches are either open or closed circuit. My questions is can someone explain to me the differences and also...

Thanks guys I got the assembly. Only thing is I may need a carb so I will let you guys knownnext week.

Hello all. I am now working on a 7hp Tecumseh for my buddy's minibike however, this evening when we went to pull the rewind there was no tention. After removing the shrowd I found the plastic rewind with a single metal flap that engages the cup had broken. Please see the pic below. If anyone...

7hp schrowd

Thanks guys I just got one. :scooter:

Just as an FYI, The one I have has the manual choke without any fancy linkages except to hook up to the throttle. It also has the diaphram on the side held on by 4 small screws.