Search results
-
S
all brand new box stock project engine parts
Everything here but carb- slap
- Post #9
- Forum: Mini Bike Parts
-
S
clone lots of compression after head and cam swap
It's the mamba but no comp release might get one with it- slap
- Post #20
- Forum: Honda / Clone / Predator
-
S
clone lots of compression after head and cam swap
Lol yea but what the most lift I can go with my current setup with no modification- slap
- Post #18
- Forum: Honda / Clone / Predator
-
S
clone lots of compression after head and cam swap
dam looks like I need another cam so what is the biggest cam I could go with on this setup and still be able to crank it- slap
- Post #15
- Forum: Honda / Clone / Predator
-
S
clone lots of compression after head and cam swap
compression is just way to high I lifted the who bike off the ground trying to crank it I cant seem to get the valve lash set when I set it I tighten down on the 10mm head nut and even back off on the 14mm bolt and its still tightening down to much its prob me not doing something right but it...- slap
- Post #10
- Forum: Honda / Clone / Predator
-
S
clone lots of compression after head and cam swap
Trinik it's the head I got from you- slap
- Post #7
- Forum: Honda / Clone / Predator
-
S
clone lots of compression after head and cam swap
I been doing it like that I even tried putting a bigger sized feeler gauge and I'm still have the same issue I adjusted them so many times I'll try again tomorrow had to walk away it was stressing me lol- slap
- Post #4
- Forum: Honda / Clone / Predator
-
S
clone lots of compression after head and cam swap
Ok i got a brand new box stock project engine just put in a black mamba cam a 22cc head milled .65 26lb springs and 26/25 valves this is my first engine I did I can't seem to get the valve lash set right when I tighten down on the 10mm head screw holding back the 14mm one the gap closes to...- slap
- Thread
- Replies: 19
- Forum: Honda / Clone / Predator