Search results

  1. A

    Wards T-555 in Cypress TX

    I need the room in the garage. Nice powder coat Predator 212 built--pull start rope needs replaced, probably went too far with the head milling/brutal compression. nice trike in good shape make me an offer. Andy
  2. A

    Wards T555

    http://rover.ebay.com/rover/1/711-53200-19255-0/1?icep_ff3=2&toolid=10001&campid=5335845805&icep_item=153282812382 it's mine so feel free to ask any questions here. Auction without reserve.
  3. A

    Wards T555 $1000 OBO

    David, I've called, left you a message with my cell phone number.
  4. A

    Wards T555 $1000 OBO

    Reduced $600
  5. A

    Wards T555 $1000 OBO

    need to make room in the garage..... Located in Cypress/Houston Texas Nice ride, pick up only.
  6. A

    Wards T-555 in Texas

    Rt21trading.com
  7. A

    Wards T-555 in Texas

    Hello All, I'm out of room and need to thin the herd..... I restored this T-555 over the last several years and now need to find it a new home. The powder was done (well) by Trail Performance, the seat by Jimmy Judd, and the engine by Uncle Franks. I reassembled the trike with new...
  8. A

    Heald VT-24

    Had crank cut and tapered 25 degrees to match the comet 780 driver. 0.30 over Pistons, .050 off the heads and valves ground. Keeping the compression reasonable to keep the starter alive....hopefully I can make progress next weekend
  9. A

    Heald VT-24

  10. A

    Heald VT-24

    Seat pan/fuel tank on frame. I hate to cover it with foam and a cover. The fill will be rear center and a shallow sump built under the large hole
  11. A

    Heald VT-24

    Intake bottom
  12. A

    Heald VT-24

    Intake, sheet metal built onto the stock Honda Single TM 38 flat slide carb
  13. A

    Heald VT-24

    About 1/8" clearance between frame and caliper
  14. A

    Heald VT-24

    Brake and drive sprocket
  15. A

    Heald VT-24

    Jackshaft caliper mounted
  16. A

    Heald VT-24

    Machined fill nozzle for the fuel tank
  17. A

    Heald VT-24

    Seat frame, will hold a couple of gallons of methanol
  18. A

    Heald VT-24

    Header flanges done
  19. A

    Heald VT-24

    Braced jackshaft mounts
  20. A

    Heald VT-24

    1/4" motor/jackshaft plate welded in
Top