Ok so the engine is stock, I’m not sure where to set the idle screw or the air mixture screw. That’s my main issue is idk where the stock location of them were. I messed with it too much. I know it has a 130 main but I’m not sure about pilot yet.
I ride trails not road so I’m never really in...
I have jets on the way, I bought 3 different mains and 3 different pilots. With the 130-15 where should my screws and float be set? That’s the most confusing part to me
Hello, My name is mason and i recently purchased a coleman bt200x mini bike
I purchased a mikuni (chikuni) 22mm carburator kit with filter for it and i cant seem to get it tuned correctly......
i have not touched the needle nor have i replaced any jets. I am currently using the stock jets in...
Hello, My name is mason and i recently purchased a coleman bt200x mini bike
I purchased a mikuni (chikuni) 22mm carburator kit with filter for it and i cant seem to get it tuned correctly......
i have not touched the needle nor have i replaced any jets. I am currently using the stock jets in...
hello i have been reading alot and i am also in need of assistence if one of you guys could head to my page and check out my thread and give me some insite and or details on how i can fix my problems i would greatly appreciate it!
thanks!
i am in dire need of help as well. if someone could come to my thread on my page and read the discription and give me a little insite i would greatly appreciate it
Hello, My name is mason and i recently purchased a coleman bt200x mini bike
I purchased a mikuni (chikuni) 22mm carburator kit with filter for it and i cant seem to get it tuned correctly......
i have not touched the needle nor have i replaced any jets. I am currently using the stock jets in...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.