Search results

A bunch of mike clements parts as a lead up.. There is a billet 3hp cylinder head. Finally found pictures of the blow through Moroso pump he put on an OHV.. Pretty cool after all this time we can grab the part number off that Moroso. I assume it would be a solid built 3-4 vane rotary pump made...

Absolutely not. If I lived the million wouldn’t cover the hospital stay after.. I’m in the hospital bed and there telling me my million dollars is gone my insurance tapped and now I’m 500k in debt for the remaining hospital expenses..

I picked up a new phone and wow is the tech always watching. This new phone integrates instagram videos into the Facebook video tab with no instagram account needed. I made a Facebook post that included the word accumulator.. Sure enough the Facebook video tab is now showing instagram videos...

The farm is pretty clear at 23 degrees should be 55 tomorrow.. The past few days have basically confirmed we have about a month left till I’m outside in a t-shirt. Then May June and it’s suddenly hotter then hell in July.

If I had the brake caliper from your bike to use on my bike I would start looking around for an 11.7mm od bushing. 11.7 may be a tad bit snug in terms or fit so the bushing could get a quick pass on the bench grinder to become 11.6mm honestly I‘d pick up a few spares it might end up a trial and...

Sold

BUMP $25 shipped PayPal G@S

Sold

We got it sorted :cool::cool::scooter:

@sparkwizard It’s still the same picture from when you purchased all the briggs parts from me.:scooter:

I am not scamming anyone. Now we have that sorted are paypal.me links ok?? I sent my name number and PayPal link and got this back..... As always I only accept goods and services.. I have said this since joining this forum.

Bump everything pictured above $150 shipped

I have a couple 3hp’s in the back not sure on the date though..

Bump Everything $190 shipped

Thank you!!!!

Do your top bars pull out of the faceplate if you undo those two bolts?? I’m wanting to attempt to remove mine but not sure if there pressed together and bolted.

Pulled from a Gilson/wards 525 $225 shipped

I’m also wondering how it mounts on his chopper as my gilson clutch cover fits my chopper ALMOST perfect. The gilson has a bottom mount. The choppers have no bottom support for the clutch cover. There is no way you can ride without the bottom support the clutch cover would rattle until it...

The $200-$300 isn‘t any trouble. He is firm on not splitting it up. I’ll keep everyone updated.

Seller said it all has to go $300 and I’m in the middle of another project at the moment. I really only wanted the Azusa looking frame and Honda.