Search results

Shoot no. Haven't had a minute to pull it into the shop. Maybe over the long weekend.

I will check the oring in the block that seals on the carb. I "think" the new carb came with a new one but I'm not certain. The air filter was cleaned when I prepped it to run the first time.

I have a B&S on my push mower that runs poorly. I bought it at an auction for $2 because it wouldn't start. The ethanol gas from 3 years ago had gone bad. I cleaned the tank and carb, changed oil, and gave it a few pulls. It fired right up and ran ok. After a little mowing it began to surge and...

10-4. I haven't opened it up yet to see.

The hard plastic spark plug cap got broke on my engine. Is the coil wire replaceable on these or is it molded into the coil? Pictures online make it look like it comes off the coil.

I love the scene when Lloyd comes riding up on this and Harry says Just when I thought you couldn't do anything more stupid....you go and totally redeem yourself!!!

It has a disk brake and twist throttle off a little Chinese dirt bike.

Hello all. I found this site while looking for jetting info on a Predator 6.5. Lots of good info on here. This is my latest project, not sure what to call it. It tops out about 25 mph and does wheelies with ease.

First pic attempt

Seemed like a good use of a Predator 6.5