Search results

I did some mods on a HF clone, 22 mikuni carb and new air, idles great, it is very quick but it dies down at full throttle, i tried adjusting the intake screw on the bottom of the carb float, but still not holding at full throttle? what should i try?

how about this, my new carb leaks gas out of the bottom float hole, is that supposed to happen or do i need to adjust the screw at the bottom?

I'm building a azusa kit, using a clone from HF, the comet clutch and rear sporket are not even close to lining up, if I flip the clutch they line up nice, will this clutch work this way?

anyone ever build one of these mini bike kits that are all over the net, 5 in wheels, 6in wheels etc, are they "OK" or do they uh..suck

anyone know where i could buy a chrome "looking" cylinder shaped gas tank? like seen on many bikes on this site

How and what do you use to hook up a throttle to the popular engine being sold at haror freight, is there a kit thta makes it easy? I want to put this motor on a basic mini bike kit

anyone know about any east coast mini bike shows this year on the east? i'm in NJ and i'm new to the show scene

How do you get the throttle to hook up on the harbor freight motor for the doddle bug, I was looking at both in the store and i'm not sure of an easy route? If I could do it I might buy both things

anyone have any info for min bike shows this year on the east coast? I'm in NJ

hello out there,I 'm steve from NJ, just found this site after looking at old mini bikes on ebay and other sites, had one as a kid and i'm thinking of getting "something" to get back into it, actually was thinking of the doodel bug and replacing the motor. mostly because it is a "new" frame...