Searching for a cat Dominator frame. And a gas tank;and o yeah ! A rear drum cat split rim..;so any of you catminibike people out there see this post please help a fella out !...Thank you...:hammer:
If the flywheel fits under the shroud and has the same diameter as the shaft it will work i done it before and my engine ran dam good ... Those two flywheels look to be equally balanced...
Say happy new year man!..im not on the site much these days but i am trying to find a cat Dominator tank an frame with the original paint...but i would like to see a photo of the tank you have if possible and a price..
Looking for Supper Bronc and Heath minibike seats with the company stamp on the back of seat good shape original seats or new prefabricated seats !.... If any leads please pm a guy. ..thanks:hammer:
That bike suppa bad ass !... I just got a vt 5 and vt10 and I have my work cosmetically cut out for me...if you here of any one prefabricating super Bronc or Heath seats please pm me ... Great bike you got man..l
you should buy a bicycle sissy bar and cut the ends off to fit 6 to 9 inches above the rear of the seat you or they will never know the difference with out looking for an original factory bolt hole pattern!...try that though ....GOOD LUCK.
I always got the Tecumseh timed by luck and i know i'm not getting pin point timing. these engines run like a Bat Out Of Hell when timed right and sinked in with the carb...;but will some one tell me how to time the point's exactly?.. and set the coil to da flywheel?...
I'm searching for a pair of 1969 Rupp fork tubes with the drum brake slot key welded at the fork tip witch holds the wheel drum from spinning......pm me if you have ?.. THANKS:hammer::hammer:
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.