Search results

Lots of leftovers for your parts bin!!! 5/8 Axels, spacers, nuts. Some fine thread some course. Some are new some are used. manual disk brake caliper, new Scrub brake pad Exhaust flange uni filter 2” inside diameter. new. With can of filter oil. 10$ local pickup in Long Beach. 20$ shipped to...

Two 6” diameter aluminum wheels for a minibike with bearings. Very nice condition. Rear tire has a brand new 13” diameter Carlisle tire, brand new tube, and a 55 tooth split sprocket. not sure if they came off an Aggie but they look like it. 60$ local pickup in Long Beach or shipped on buyers...

4” Tristar wheel with a 9x3.50-4 turf saver. Lots of tread no cracks. Holds air. Accepts standard 1 3/8 OD bushings. 40$ local pickup in Long Beach or 60$ shipped USPS flat rate.

$9.99 local pick up in Long Beach CA. shipping on buyers dime. manco delta 1 seat. Will need some duct tape. So I will throw a usable quantity in with the sale -Gorilla tape - not the cheap stuff.

Cool little guy. nice condition. @8” long and 6” wide $10 local pickup in Long Beach $20 shipped to lower 48

Shroud with good pull start Gas tank Piston Muffler 10$ for all local pickup in Long Beach or 25$ in a flat rate USPS box to lower 48

11x4.00-5 turf saver 4.10/3.50 -6 universal with good tube 5.30/4.50-6 universal with good tube Some small cracks but all still usable. 20$ each or 45$ for all local pick up in Long Beach. I will ship on buyers dime.

No time to finish. Not sure who made it. Bought it at Mac’s yard sale several years ago. Roller. Has Pocket-bike wheels and uses T8F chain. Brake set up is finished. Was going to make it 24volt electric. I have a spare slick that matches the front that is included. 60$ local pick-up in Long...

One brand new cheng shin stud 4.10/3.50-5 One lightly used Duro slick 4.10/3.50-5 $5 each local pick up in Long Beach CA

6” Manco wheel good condition. Not drilled for sprocket. located in Long Beach $10 pick up or 25 in a flat rate USPS box to the lower 48.

I need a bigger sprocket. Can anyone advise the correct bolt pattern? Original Aggie 97 wheels. thanks!!!

Both for 20 bucks. Or one for 20...bucks and you can have the other one for free. Local pickup. 2.5 started up no problem. 3 hp has spark and compression but refused to run even after I cussed at it.

Carb is new. Filter and adaptor are not. 20 bucks shipped lower 48

For 3/4 shaft, near new 20 bucks shipped lower 48

From my jr. Dragster days. 30 shipped.

No rips or tears. Comfy for your nalgas. About 18” long. 4” in the front. 7” in the back. Give or take. 10 bucks. Buyer pays shipping. Local Pickup is always nice.

Cool little thing. Kids are pissed that I am trying to sell it, but I need the room. I will throw in the power products, but it will need a new crank as this one is tapered and threaded. Let’s start at 75 bucks and buyer pays shipping. Local pickup is encouraged.

Brand new. 13x 5.0 - 6 5 bucks. Pretty sure it has to go in a large flat rate box. So add 19 bucks unless you can pick it up At Me Casa

Runs nice. Bought it a few years back on a work trip to Alabama (they didn’t sell them in CA back then. Not sure if they do now) Had it on an Azusa. I have too many little engines. Time to thin the herd. 25 bucks. Buyer pays shipping.

Autometer tach from my jr dragster days. Works. Has a dent in the bezzel. 50 shipped lower 48.