I made up my own throttle. I used a spring, a couple of small fender washers for each end of the spring, and a small clevis with a set screw to lock the cable in place. No govener.
Im looking to upgrade my 30 series torque convertor belt to a good quality kevlar belt. I am a bit confused on the correct part #. Also, any info on a trusted vendor to purchase one is much appreciated. Thanks!
Denny
I have the offset exhaust flange on my B and C series HS50 as well. I ordered the correct exhaust gasket off of ebay. The header that I ordered from OldMiniBikes has the offset bolt pattern flange also. I would think that header would work on the HSSK50 too.
Its a nice 148cc Briggs flathead from a snowblower, model 09a413 0202 e1. Just working out how im going to hook up my throttle. Suggestions welcome.
Also, I am substituting a Champion J8C wich seems to be working very well. Is this plug ok to run with this engine?
Thanks!
Denny
Alaskanrocket, that extra shaft is the end of the cam, used for power to drive wheels on a snoblower, or whatever. I will be replacing the cam with a reguler stock cam and side cover with only a thru hole for the crank. Also the new side cover will have the 4 bolt mounting pattern for the tc.
lol6
I will be using it on a Baja Warrior as well. The tank is flush with the side cover. I will be adding a stock cam and sidecover with mounting holes.
I also am going to order a new tank. The old one is shot, gas sat in there for years and turned to rock hard varnish, the little reservoir for...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.