Search results

How about a Heat Shrink. Layer as required.

If you don't have access to a tree and tractor this would also work.

You didn’t grow up wanting to be a goatboy?

I love a good mystery. If this thread were a Hardy Boy Book it might be called “The case of the miss firing plug” or “The lost Flame”.

"No carb, no exhaust and starter fluid in plug hole" I've never tried to test a setup like that. Has that worked for you in the past. Maybe try a different plug. I know some of my 20 year old chemicals aren't as potent as they once were. How about a shot of starter fluid in the open intake...

Only rich kids had clutches. Every mini bike or go cart I had was direct drive….push start and jump on.

This is one of the best resources out there for your Tecumseh questions...Thanks CFH http://www.pinrepair.com/minibikes/tecumsehmb.htm

https://www.facebook.com/share/QXPPeoLJJM24QmYk/?mibextid=79PoIi

Are you asking about the oil for the side tank or the Engine/transmission case. I believe a 30w 2 stroke oil goes in the tank for injection and a 10-30 motor oil goes in Engine/transmission case.

I knew it was pretty iffy, but I had to give it a shot.

He must have sold. He never responded and it’s not listed now.

I told him I'd take it and can pick it up tomorrow...we'll see what happens

Nice work.

something like that might have been an idea. Once I got the primary dent out I could have done more with some type of inside dolly and a hammer. I've been watching Forged in fire.. I think I would have been sent home after the first round.

Yep. It's not going to be a show bike. I just want to beat around the farm on it. I might try to make it a little neater later.

Not perfect but better than it was.