With or without fuel line holes is fine, pre 1973 (serial plate instead of stamped shroud). throttle mechanism and serial plate not needed, but would be a nice bonus
I need a black original paint blower housing and/or recoil for a 71 hs40 so it needs to be curved top and can be from other years or models from early 70's. Thanks
What is the difference in the housings with the recoil bolts at 3 - 6 - 9 - 12 and the housing that has them half way between at 1:30 - 4:30 - 7:30 - 10:30? Is this changeable or do you have to swap out the cover?
Second question - What does it take to convert an HM80 to electric start? More...
I'm restoring an HS40 for a Rupp mini bike. One of the 4 studs in the blower housing for the recoil starter is stripped beyond repair. The studs look like they are pressed into the blower housing from the inside. (Hopefully they are not welded in!)
I'm wondering if I can press out the bad one...
These parts are for a TECUMSEH H-70 Model 130054A
Recently had these parts all show chromed and have only been taken out of the wrapper.
Selling as a complete set only. The blower Housing has the optional starter motor popout
H-70 Blower Housing
H-70 Blower housing backing plate
H-70...
Here is a piece I no longer plan to use in the near future. The blower housing in very nice condition, almost rust free, no dents, except a very miniscule nick at the top edge.
All stickers are still there and it comes with a great working recoil mechanism and the starter cup and screen which...
Does anyone know if a vintage H35 blower housing (shroud) fits an early 90s model? If it does, anyone have a vintage one and willing to part with it. Going on the ARCO.
Thanks!
Im looking for a nice blower Shroud (no extra holes) for a 1968-69 correct Tecumseh H50. I also need the correct throttle linkage used on this motor for Rupp mini bikes. Let me know whatcha got.
Thanks folks!
Does anyone have this blower housing mounted tank? Can you let me know how its mounted? I see the attached part (27780) and they are calling it a reinforcement. Is it mounted with three screws right through the blower housing and this reinforcement piece into tankđ?
This engine ran when tore down. Had excessive carbon build up on the piston. The bore is std and mint. Have all the parts. Good engine to reseal and run. Was a snow blower engine. $50 plus shipping from Grandville Michigan. Shipping will be usps. Can text or email photos.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.