Iv never used a nitro oxide system and need help I don't want to wing it on this one. I have a raptor tilly carb with a manifold. Should I just get a sneaky Pete system and follow the derection? All help is welcome and appreciated.
All suggestions are welcome and thank you in advance.
I made this tank from a old propane bottle, the fill cap is from a tin container that had a metal screw cap, it's just soldered on. Capacity is 1 litre approx.
The brass 1/4" compression fitting is soldered in too, tank is vented though a small hole in the fill cap with hole in the gasket...
Looking for a grip at least close to this, its for the scrub brake pedal on my mickey/KOL this one is a Flex-grip 5/8 inside and around 2 3/4" overall
there is some 1/2" ones on ebay I dont know if I can stretch them enough or not and they are also listed as 3" long. If anyone has any...
Like to see some setups using stainless bicycle jugs or similar for fuel tank. How are you guys attaching the fittings, venting, etc? Olbriggs?
Thanks
KD
Stainless : Welcome to New Wave Enviro Products
i found this on youtube:smile:
kind of funny to watch. couple kids hooking up a poor man's
nitrous bottle..................:scooter:
YouTube - Motor Scooter with Nitrous Oxide (Whipped Cream)
About 8 years ago, an older lady that lived across the street from me asked me to help her clean out her basement. Most of the things in her basement I was sure hadn't been moved much in the last 25-30 years.
Anyway, under her stairwell was a pantry that was full of old whiskey bottles, some...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.