I'm looking into purchasing a billet flywheel, billet connecting rod and piston combo, for a 212cc predator if anyone got some links or suggestions for some it would be greatly appreciated..
confused about the built in timing, magnets, coil bracket? This would be the first billet flywheel I...
I found rod!
Can't remember what it for lol.
Wrist pin is .628
rod journal 1.378.
center to center is about 3. 181
Marked fan on one side, and 251 4 on the other
Strange marking on it looks like a bomerang
I have no ide what it fits.
After some though
This may be a rod for a...
Prototyping has begun on the new Raceseng connecting rod design. heres a little sneak peak at what we have been cooking up here at the shop....
http://www.raceseng.com/connecting-rod-under-development/
I just put a 3hp briggs flathead on my db30, I want to connect the existing kill switch, I have an idea how to do it, but have no time to mess around, could anybody please post pics of how it hooks up for me? Thanks. I am pretty sure that one goes to the coil and the other to the ground but I...
These are being made right now and will be available in the next weeks. Up for sale only a couple being made, Billet H70 connecting rods. Dont let this happen to you! check the pics, if interested contact pdlsa10@aol.com
Does anybody know the dimensions of a hs50 connecting rod? wrist pin hole size, crank pin hole size and center to center, or rod length? Or know of a place where that info can be found ?thanks
I thought I'd check with you guys first before I order one from a Tecumseh dealer...one of the members might even be a Tec parts supplier, who knows?
The rod is for a OHM 110...thanks.
...it's an 11hp mini bike engine...wooooohooooo!
I need to get a few #35 roller chain connecting links but not sure where locally to get em.Does a chain store,hardware,etc carry em? I was looking online but I'm not paying the minimum shipping charges of 5 - 8 dollars for such a cheap part.Where do you get yours? Thanks so much!
As my son is getting older I am debating whether or not he should be allowed to ride on an ungoverned clone motor that has no other mods done to it. Do you ride or have in the past a clone motor that is ungoverned with no other mods done to it?
I thought I had seen where someone is making these in a high strength material for the old Tec HS 40 and 50 motors. Anyone recall where I might locate a source for these ?
I have found a video of someones connecting rod FAIL. There is a hole right in the block. Its pretty shocking. This tells you that no matter what you have in the engine, DON'T OVER REV. Waste of a perfectly good honda GX200. Like 300 bucks down the drain.
YouTube - GX 200 Clone Go Kart Riding...
A few months back I stripped new Lifan 6.5 I have of this rod and spring for a buddies bike.
I know a lot of clone guys go with Mikuni carbs and do not use this rod and spring so if you still have and want to sell it please let me know. I need to keep this one engine stock for my Nephews...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.