help??

  1. DaveL12

    2 more projects! I.D. help??

    Any idea what these lil guys are? Picked them up earlier today
  2. SonofLiberty776

    Predator 212cc Engine Help??

    Hello, I'm new to the forum, so hello all. But I just got a Baja doodlebug with a brand new Predator 212cc. Well during the day it runs great, no problems at all, but my favorite time to ride is at night but that is when I have problems. It will run for a few minutes, then bog out and die...
  3. 93notch408

    predator no compression help??

    so i take the motor off my bike to put the worked head and roller rockers on it and after the install there is NOOO compression and the bike will not start so i buy a copper head gasket for it and still the same shit...then i thaught the head might be screwed up and thru the stock head back on...
  4. waltsuz

    Vintage Kart help??

    45 years ago my father came home with a go kart sticking out of the trunk of his car. I would love to figure out what, and who manufactured it. From memory it had 2 Homelite 2 cycle motors. The kart was all Aqua blue the same color as the Homelite motors and chain saws back then. It had a chrome...
  5. nyislander

    Help??

    Above is an image of where there once was a spring for my baja warrior which I unfortunately mangled. Without it the bike will not idle or start properly. I thought i ordered the correct one off monster scooter parts but after looking at the bike closer I am not sure it is. E05-1296 -...
  6. dajsnipe

    little help??

    I picked this up at the Detroit swap meet last weekend, anyone know what it is... and dose anyone have a cover for the clutch they would be willing to sell? Or even any expertise on making a cover -It doesn't have to be pretty, its a rider. Thanks for the help
  7. R

    Honda GC160 throttle help??

    I am sorry if this topic has already been covered, but I spent about 30 minutes using the search function and came up pretty much empty handed, so if you know of a thread, please link me. I know this motor doesn't have a big following, but I'm sure there are a few out there. So, my question...
  8. E

    Frame ID help??

    Hi guys, My name is erik and i'm a newbie to OldMiniBikes from califonia. I just pick up a couple of frames, and since i'm new to this i got stuck on one particular frame. Here is a picture, and any help will be greatly appreciated. Thank's in advance.
  9. johnf.357

    Who is familiar with mik.22 mm carb jets Help??

    Me again I am trying to find out what size main,and pilot jet are in the (22 mm vm -133)carb I just got? was not able to find out from buyer,I pull the main out but did not see any numbers,and the pilot jet I could not read,but will be able to read with a mag.glass soon.. If I can find...
  10. poppa

    tuning help??

    I did a bike for my grandson,and it has some hesitation,enough that it will die.It will idle fine and runs good but you have to nurse it to get it going. I made the exhaust(one point of my question) and the intake(another question). These were what I came up with just to get done. I was hoping...
Top