help/advice

I got a baja worrior at a garage sale motor was bad .went an bought a harbor freight hemi to replace old motor is their a way I can make the clutch from the original baja work?if not where can I get a clutch that will work with the hemi. Any help appreciated.:confused:

Hello, I got these shocks at a local store for dirt cheap. I believe they are Jin Suspension LJ400A coil shocks. Currently have them set up on the rear of my minibike. One of the coils has 350lbs/Inch written on it. Have them adjusted all the way for a softer ride, but they are still way...

The $40 SketchyTrike I picked up over the weekend has a Salsbury Corp. 500 Series driver clutch for its torque converter system. It is misbehaving (I think) and I'm not sure what I should do. It seems to want to throw the movable sheave at the belt WAY too soon (like at...

I want a metal cutting vertical bandsaw in the shop and tripped onto this; G0640X 17" Metal/Wood Bandsaw w/Inverter Motor NEW! | eBay I would love for those who are knowledgeable to tell me why/why not! Thank you in advance! Paul

I bought a super bronc from a guy in Washington state and I live in Ohio and Im trying to find out the best way to have it shipped to me without it costing a small fortune. I am trying to make it as easy as possible for the seller, and he only want to lower the handle bars and ship it that way...

Took a long time but I have a New new Style DB30 I weight 210. Seems to run fine but it will pull me only on a dead level surface.(slowly) I have a slight incline driveway and it just sorta stops and chugs. I have the throttle stop out(it gets full throttle) and if you lift the rear tire off the...

Put a smaller snowmoble engine in a Bronco?? frame and it doesn't launch like I hoped it would. Seems to run ok. Suggestions?? I was thinking of trying a bigger rear sprocket,where would I get?? #40 chain.