Looking for new or used in new condition 6.5 crank. I'd prefer a real Honda crank but a new Clone crank would be fine. I need a price shipped to 92336.
Thx.
This is the standard (not the modified) .265 cam that AGK carries. Honda/Clone cam.
This is out of the same engine the billet parts were in; very little use. This really is a nice little starter cam, good for about 6000rpm. If you have a mild build, this is a great add-on for it...
used AGK .308 cam in good condition. i bought it used and never ran it.
$55 shipped, Paypal or money order
once again, will trade for a 5hp Briggs billet flywheel w/ cash on top if necessary to make it happen.
I need some 1:2 ratio rockers for a Honda/Clone head. I see them at several online stores, but though I'd check here first to save a little on shipping. We all know it doesn't take a 10 dollar box to ship ittty bitty parts :thumbsup:
Thanks folks.
Hello,
New here, just installed a HF/Greyhound 6.5 engine on my snow blower.
Looking to add a lighting coil/flywheel to the setup.
Let me know what you got, thanks.
This is a take-off carb from a genuine Honda GX200 engine. It's a Keih Hin carb. I have shaved down and polished the throttle shaft and shutter for better flow. Also comes with choke hold and air filter adapter. Carb is jetted at .92 to work well with the open air filter and header...
For sale I have a RLV honda/clone header that I believe is 13-14" in length, but not positive on the exact length. It was on my engine for maybe 20 minutes of actual run time, otherwise it has just been sitting. $20 plus shipping.
For Honda and Honda Clone gx160 (5.5 hp) and gx200 (6.5 hp) Engines
This is the size list so far of the bolts and some torque values. Please let me know if you have anything to add. Please note these are the stock sizes and torque specs, please when installing aftermarket parts consult the...
I have a Dyno drop in 265 cam for sale....$35
I have an ARC Billet flywheel for sale...$80
I have a new header for sale....$25
I have a used Honda flattop piston with good rings...$15
I will ship in US only. If you are within a 50 miles radius I will meet you half way. Parts are sold...
Looking for the lower profile gas cap, as my genuine honda cap is too large to fit into the frame. I've heard the genuine honda cap seals really well. :smile:
I'll trade my cap for your smaller cap!
Raceseng is a father and son motorsports product design and development studio. We recently finished the development of our first 1/4 midget and karting product...
The Rev Rocker is a billet rocker arm for the Honda GX and Clone 160/200, see the link below for product details:
Rev Rocker...
Just finished up the motor this week. Here's a short video clip, hasn't been tuned at all yet and no load is attached. We were just starting it for the first time.
Hopefully get some more video before winter kills us here in Michigan :sadcrying4:
YouTube - GX390 Mini bike
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.