mock

I have three gatling gun exhaust pipes. Just in time for the 2016 build off. All three are powered by 12v. Two of them rotate and have red LED lights that show out of the barrels. The third exhaust only lights up and rotates from wind. These are mock exhaust and not made to be connected to an...

Trying to make important decisions

After you folks helped I.D. my frame, I went to work. I'm waiting for remaining parts, but here is a pretty good mock up.

I have decided to shoe horn the West Bend 820 into the Tom Thumb frame. I cleaned all the frame and mocked up the rear axle, wheels, slicks spocket and engine. I have to move the carb off the top of the engine and use a bottom stuffer for the carb. I found an NOS GEM unit in Calif and it is on...

TOM THUMB TRIKE MOCK UP

Bonanza Brake & Sprocket Mock Up

Bonanza Brake & Sprocket Mock Up

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up the electrical system.

Starting to mock up electical system.

Starting to mock up electical system.

Got a Comet TAV-2 mounted on a Briggs. If I mount it with the driven below the driver (next set of holes down) the plate hits the engine oil fill. With it 90 degree's with the engine as shown it clears but the driver is maybe 2 inches above the engine mount. Would you modify the oil plug and run...

Thought it might be nice to see a few ideas and designs of things that would be neat to build. Do a mock up of something and post a picture on this thread. Bought two Razor children's plastic electric bumper cars today for $25 and set one here alongside my Taco: ...Just need the...