necks

Looking for some more Briggs or even Tecumseh metal filler necks from old tanks that may be rusted or beat up and not useable...I need the smaller necks, 1.5" approx...

looking for several Briggs filler necks from old tanks that may not be worth saving as long as the necks are in good shape..

Looking for some Tecumseh metal filler necks...if anyone has some rusted, dented or otherwise not worth saving tanks with good filler necks I'm interested in whatever I can get... Briggs necks considered also...

wondering if an mx tanks came with fiberglass filler necks and if so were they were certain years?

Where do you buy Briggs Fuel tank filler necks?? Found this old pic

Good day everyone, A couple questions in regards to the steering neck of the forks with the spring under the neck itself, not sure how to describe it better than that. Are these strictly used for bushing type necks or can they be used for bearing necks as well. If used with bearings will...

Ok, I have been kicking around the idea of making up my own cylinder gas tanks because I need a couple for my bikes. But I am hung up on the filler neck and cap. I know I can buy em from chopper shops like Lowbrow Customs, etc. but I have the stuff to make my own so that's what I would like to...

Looking again for some filler necks from old briggs, Tec ect tanks.... all I need is the necks so the tanks can be rusted or dented or unworthy of messing with as long as the necks are good...

looking for some filler necks from some old metal tanks like Briggs or Tecs...need at least 1/2" lip around the neck after it's cut from the tank(s)....

I'm looking for some filler necks from briggs, tecumseh, ect metal tanks...I dont care how bad the tank is as long as the neck is good and solid and not all kinked up.. If you have some and have a way of cutting the necks out leaving at least 1/2" around the neck LMK what you need in...