seal

Anyone know how much oil to put in the fork after changing seals?

Have tried three seals and oil insists on making its way through the seal into the clutch...then its nogo. With new oil takes little time before it smells like gas in the oil as well. Very light scoring on the shaft and cast-in bearing. Its a cool-bore engine. If I clean the oil from the clutch...

I guess probably not, but anyone have experience replacing 97cc crankshaft oil seals? Finally had a failure on 97cc. Flywheel oil seal let go, funny sound and leaks oil. Found a couple of places to buy OEM seals, but would like to get a little better oil seal. I think the OEM crank seal...

Would this crank seal sold at Ombw Part number ARCDJ-1300 fit as a replacement for a predator 212 clutch side?

I am sourcing some new crank seals for my fleet of Sachs Saxonette 50 2-cycle engines. I've got a few NOS seals but they are pretty dry and stiff after 40+ years sitting in a drawer. Common shaft seals are made with nitril black rubber (NBR), but the heat range on NBR only goes up to 200...

Just started semi-restoring a Gilson Tiller with a 5hp Briggs. Bought it cheap and it worked. Needed chains, bearings, seals in both trannys, but that is already done. Blasted and painted most of it and here is how it sits. Since then I have been trying to find the engine shaft seals I...