Could use some advice from some experienced arc welders.
I know since Miller lowered the OCV TO 80 is the reason whip and pause does not work like it did with the older machines.
If you drag, it is supposed to work.
Any opinions and advice on technique?
Thanks,
Jon
He guys so with m other post i was finnaly able to get the correct parts for my go kart but i have another problem i broke my bearings es i bought some new ones but i would like to know is there a proper wa to put bearings on m axle or do i just oil m axle ith engine oil and slide it on this is...
Does anybody have any technical tips on the best way to drill a bolt? I am fabricating a clutch band brake set up and need to drill a hole through a 5/16" bolt that the band brake pivots on for the brake cable to pass through. How best to center punch and drill it w/o having the punch and bit...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.