Im pretty sure there all the same with the slanted cylinder which causes the tav fitment problems. You can cut a piece of the tav2 back plate but u will still need a lot of room to mount it correctly. I know a 5 hp briggs wont have any issues but its not a clone.
It was an issue when I had my small mini bike frame (cat), I could not get the tav2 aligned correctly on the motor because the frame was to small and the tav2 never worked properly.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.