big block Honda/Clone performance parts

125ccCrazy

125ccCrazy

Well-Known Member
#3
#3
trinik7597 said:
bullfrog motor sports has a nice 92mm flat top with valve reliefs .... they just sold that and a rod combo for the 420 on ebay
Click to expand...
I was looking at both flat top and domed...Thought I'd try here to see if anyone had new parts for a build they gave up on or had some good used parts...this will be going on the Tri-Sport..
 
125ccCrazy

125ccCrazy

Well-Known Member
#5
#5
I just picked up some raceseng roller rockers off Bob's and a billet intake off ebay, 34mm Mikuni, I have new 5/16 pushrods from a previous project... slowly gathering parts... I'm leaning towards staying with a stock flywheel with charging/lighting coils...the engine will never be free revved to the point of exploding it, stock flywheels don't scare me plus the weight helps with carry over....I will run a dipper rod since the engine will be mounted on an angle on the stock 340 engine mount that will be redrilled for the gx440 because of clearance issues with trying to mount the engine flat..
 
You must log in or register to reply here.
Top