Bonanza Brake Hook Up

[Frisco57]

Does anyone know where I can get a threaded brake cable adjuster that will fit into this barrel under the Bonanza swing arm? (I.D. is 1/4") I've noticed that a lot of Bonanzas have a piece of flat stock with a hole in it welded there instead of the barrel. I'd rather NOT have to weld something different because the swing arm has been powder coated. Anybody got pictures of a similar brake cable set-up?

 

[Havasu Dave]

This might work, as it's OD would allow threading into your existing piece with it's .250 ID. There are other "brake step retainers" out there in 1/4-28, and the longest I've seen is 2". All of them require a jam nut of course.

https://www.OldMiniBikes.com/7-32-conduit-retainer.html

 

[Frisco57]

This might work, as it's OD would allow threading into your existing piece with it's .250 ID. There are other "brake step retainers" out there in 1/4-28, and the longest I've seen is 2". All of them require a jam nut of course.

https://www.OldMiniBikes.com/7-32-conduit-retainer.html

Thanks Dave, I looked all over the OldMiniBikes website but did not see those. I didn't know what to call them. I wonder if a good bicycle shop would have them as well?