Installed the arc billet rod with bearing....cl1 cam 18lb springs
So at first i cant even pull start the engine so i loosen the rod up
Now i can start it.....runs good then bam1
Rod bolts.come.loose an.knocks againt my block
But i cant tighten it up or i cant even pull start it
Any ideas whats going on?
So at first i cant even pull start the engine so i loosen the rod up
Now i can start it.....runs good then bam1
Rod bolts.come.loose an.knocks againt my block
But i cant tighten it up or i cant even pull start it
Any ideas whats going on?