exhaust header pipe w/muffler

#1
I tried several searchs on this with no luck.
What I am looking for is a header for a clone similar to the agk601, 602 but with a muffler and long enough to pass under the rear grab bar on the db30. I do not see this anywhere, short ones yes but long ones no. Possibly I should just ask AGK what it would cost to make me up a few??
 
#2
oldbugger,

There are several places that sell the exhaust header with a muffler. You can try our very own ..

http://OldMiniBikes.com/Narrow-frame-pipe-screw-on-muffler.html

Or NR Racing Single Mini Bike Exhaust and muffler

NR RACING

I got my header from Brute Power Pipes w/ muffler for $25 but had to have it heated and bent so that it wouldn't hit the back frame.

http://www.brutepipes.com/quarter.html

Here is mine mounted on my doodlebug..



Now I know mine doesn't go under the frame and isn't quite long enough to your specifications, but you could bend it the other way and have it be right under your grab bar and ask the guys at Brute Power Pipes to possibly extend it several more inches.:thumbsup:
 
Last edited:
#6
I picked up one of Chris's custom headers and pipes and it is well worth it. Looks great, has a support bar and is painted. Blazzing fast shipping also. Also as hot as that header gets, I would not want it anywhere near my leg, and Chris's header is tucked under the seat.
 
#8
That is more like what I am looking for.:thumbsup:
I am going to mount this on a new Predator 6.5 engine so black is perfect. I notice that the brace goes to the extrusion that is drilled and tapped on the cylinder. The new Predator does not have this extrusion in anyway, could it be mounted with the brace running to the rear exhaust stud or do you think it would be too much a strain on the stud area?
Give me a price.
 
#9
Pictures of the bike the header is going on:
Baja Blitz new John Deer Yellow paint with the Predator engine.
Yes, the seat is on a hinge and is held down with a spring, it's a reminder NOT to lift the back of the bike by the seat, also makes it easier to get to the linkage etc. I do this on all my bikes
 
#10
the headers are $85 + $11 shipping

each header is custom made to order. On Predator engines the support strut will have to bolt to the valve cover or to the bolt on holding the shroud on the side of the cylinder
 
#11
oldbugger,
That engine looks right at home in that DB- nice bike!
As that Predator engine is a California "version":eek:ut:, any clearance issues when removing the gas cap?:confused:
 
Top