Rupp secondary bushing help

[ZR9B]

seems while my project( 72 rupp hustler) has been apart so long I have lost the bushing on the driven clutch...any chance anyone can measure the length... I should be able to get id and od from the shaft...or can anyone see why it may not be a good idea to make one?? something I'm missing? any input would be helpful...thanks

 

[ZR9B]

Does anyone have one they could measure for me...I'll buy you a beer....

Sent from my HTC6500LVW using Tapatalk

 

[capguncowboy]

I don't have measurements, but I'm pretty sure this is what you're looking for

#15130 TC DRIVEN SLEEVE

or this

#15134 TC DRIVEN FLANGE BEARING

 

[ZR9B]

its the first one...I was just going to make one ...Im board at work...