Sears Roper parts wanted

zeeman

Active Member
#1
Here is the bike I have. I need: rear sprocket, rear fender, TAV cover, jack shaft sprocket, muffler. The parts can be used, but not used up. I'd like to get them a little nicer than what I have. I'll seriously consider any tav cover. Thanks. You can check out my progress in the Project Log section.

 

zeeman

Active Member
#3
Here's what the rear sprocket looks like.


It's a weld on, but I think I would like to put a flange like this on it so I can replace sprockets at will.

This is the other side of the rear wheel where the brake disk attaches.
 
#4
If you are planning on welding on a flange to mount a sprocket why not just use the wheel you have, cut down the old sprocket into a flange to mount a new sprocket?
 

zeeman

Active Member
#5
That is a good idea, I'm just not sure how it would affect my sprocket alignment. I might be able to move the jackshaft sprocket and tensioner sprocket to the right a little to account for the flange/cut off sprocket.
 

zeeman

Active Member
#9
Hey Rick, OldMiniBikes does have one, but it's not the one my bike had. Mine is taller, and mounts with two screws to the frame. Thanks for the help though.
 
Top